P3 V3 Gauge Readouts (all readouts can be individually configured to read in either Imperial or Metric units) *Depending on your vehicle, some parameters may not be available Boost (through OBD2 port using OEM sensors or with P3 analog boost sensor) Coolant temperature Air/Fuel ratio (can be read in AFR or Lambda) Vehicle speed (can be calibrated in 1% increments from -9% to +20%) Intake air temperature Throttle angle Ignition timing Engine RPM Exhaust gas temperature Battery voltage Programmable shift light Analog input 1 (brown wire) can allow gauge to read any 0-5 volt linear output sensor Analog input 2 (blue wire) can allow gauge to read any 0-5 volt linear output sensor Acceleration timers (0-60mph/0-100mph/60-130mph) Braking timers (60-0mph/100-0mph)